12HDTC

Level 2 Hard Materials Technology

Course Description

Teacher in Charge: Mr W. Anderton.

Students develop a design for a more complex furniture project which they then manufacture throughout the course of the year. They can work with a variety of hard materials that could include wood, metal and plastic to make the product. Students will also complete a study about sustainability in design. A materials supplementary cost is charged.  Technology is an approved subject for University Entrance.

NOTE: Depending on individual student’s choice of project and materials, it may be necessary to make an additional charge towards the end of the course to cover individual costs.


The standards offered in this course may be altered at the discretion of the Head of Department.

Recommended Prior Learning

*Students must choose either Hard Materials Technology, Fabric Technology or Food Technology. You cannot do more than one of these Technology subjects.*

Subject

Level

Recommendations

Year 9 Hard Materials Technology

9

Open entry.

Year 10 Hard Materials Technology 

10

Open entry.

Level 1 Hard Materials Technology 

1

Open entry.

Previous  Hard Materials Technology is an advantage.

Students need to start this course at the beginning of the year.

Level 2 Hard Materials Technology

2

10 credits in Level 1 Technology or with HoD discretion. 

 Students need to start this course at the beginning of the year.

Level 3 Hard Materials Technology

3

12 credits in Level 2 Technology including Merit in AS91356 or with HoD discretion.

Students need to start this course at the beginning of the year.




Pathway

Credit Information

You will be assessed in this course through all or a selection of the standards listed below.

Total Credits Available: 22
Internal Assessed Credits: 18
External Assessed Credits: 4
Assessment
Description
Level
Internal or
External
Credits
L1 Literacy Credits
UE Literacy Credits
Numeracy Credits
A.S. 91344 v4
NZQA Info

Construction and Mechanical Technologies 2.20 - Implement advanced procedures using resistant materials to make a specified product with special features


Level: 2
Internal or External: Internal
Credits: 6
Level 1 Literacy Credits: 0
University Entrance Literacy Credits: 0
Numeracy Credits: 0
A.S. 91356 v3
NZQA Info

Generic Technology 2.3 - Develop a conceptual design for an outcome


Level: 2
Internal or External: Internal
Credits: 6
Level 1 Literacy Credits: 0
University Entrance Literacy Credits: 0
Numeracy Credits: 0
A.S. 91357 v3
NZQA Info

Generic Technology 2.4 - Undertake effective development to make and trial a prototype


Level: 2
Internal or External: Internal
Credits: 6
Level 1 Literacy Credits: 0
University Entrance Literacy Credits: 0
Numeracy Credits: 0
A.S. 91363 v3
NZQA Info

Generic Technology 2.10 - Demonstrate understanding of sustainability in design


Level: 2
Internal or External: External
Credits: 4
Level 1 Literacy Credits: 0
University Entrance Literacy Credits: 0
Numeracy Credits: 0
Credit Summary
Total Credits: 22
Total Level 1 Literacy Credits: 0
Total University Entrance Literacy Credits: 0
Total Numeracy Credits: 0

Disclaimer

Courses will only run based on minimum entries

Selecting a course does not guarantee entry into this course

You may apply for an exemption if you do not meet the prerequisites of a course or if the course requires this for entry

Standards offered can be altered at the discretion of the HOF or HOD of the Department

Some standards in NCEA courses might be optional depending on student strengths